From behind, the tail was the one part of the R3 that never quite matched the rest of the bike. This unit fixes that. A slim [smoked] lens sits flush, sweeps cleanly outward when you signal, and fires a rapid strobe under hard braking so the car behind you actually reacts.
The difference shows up most in traffic — brighter, sharper, unmistakably modern, without turning the back of the bike into a Christmas tree.
3-IN-1 INTEGRATED — Running light, brake light and turn signals in one housing. Lose the stock indicator stalks on [applicable models] for a proper tail-tidy look.
SEQUENTIAL TURN SIGNALS — Sweeping flow instead of a single blinking blob. Direction reads instantly, even in bright daylight or heavy rain.
STROBE BRAKE ALERT — [X] rapid flashes on hard braking, then steady-on. An extra split second of attention from the driver behind. [Strobe is switchable — see Compliance note below.]
PLUG & PLAY — OEM-style connector, no cutting or splicing. [Built-in load resistor / LED flasher relay included] to stop hyper-flash on most models.
READY FOR WEATHER — [X] high-output SMD LEDs, 12V DC, IP67 sealed housing, vibration-resistant for daily commuting and canyon runs alike.
PICK YOUR LENS — [Smoke / Clear / Red]. Smoked gives the cleanest look; clear and red keep maximum brightness.